To Set the Time: Commander
I+408 - Setting Time
The following
programming procedures can be performed at any Commander I+ keystation,
provided that the Administration password or the Installation password is
entered.
Every keystation connected to the system displays the same time.
· 
Press
[i] to enter programming mode.
· 
Dial
04 to go to the Administration menu.
· 
Press
[i] to confirm.
· 
Enter
four digit administration password
and press [i] twice. Password = 0000
If the password is incorrect, re-enter correct password or
press [RLS] twice to exit.
· 
Enter
time in twenty-four hour format,
using four digits (two for the hour
followed by two for the minutes).
· 
Press
[i] to store new time.
· 
Press
[RLS] twice to exit.