1300 088 033

To Set the Time and Date: ^{Commander Vision – Setting Time & Date}

· When entering into programming mode do not lift the receiver

· From the Programming Station press the [P] Programming Key

· Press the Scroll Down Key [] until System Programming is displayed

· Select System Programming (using grey menu key next to display)

· Enter the System Programming Password – 1111

If System Programming Password fails and display shows Invalid on display

contact CCO for assistance 1300 13 88 99

· Select System (using grey menu key next to display)

· Select Time and Date (using grey menu key next to display)

· Enter the correct time in 24-hour format, (e.g. 1:30pm as 1330)

The display will prompt for date to be entered

· Enter in the correct date in DDMMYY format, (e.g. 1 January 2001, 010101)

The display will now revert back to programming menu.

· Press [HANDSFREE] key to finish programming.

· Note: Following a system reset, the time shown will be 12:00 with the date 01-01-99.

In the event of a power failure, you will need to reset the time and date.